SGDV2R8FE1A000000600 Equipment DeviceNet communication function type servo driver

Sigma -V series servo motor SGMSV.
Rated output: 2.5kw.
Power supply voltage: AC400V.
Serial encoder: 20 bit absolute value type (standard).
Design sequence: standard.
Shaft end: straight shaft, without keyway (standard).
Optional: with hold brake (DC90V).
Super power rate.
Variety is complete (1.0kW ~ 7 SGDV2R8FE1A000000600. 0kW, with hold brake).
Equipped with a high resolution serial encoder (20 bit) SGDV2R8FE1A000000600
Standard using IP67 (7.0kw for IP22).
Use example:
Placement machine.
Punch printed circuit board.
Machine tool feeding device.
Rating and specifications:
Rated time: continuous.
Vibration level: V15.
Insulation resistance: DC500V, 10M, or above.
Using ambient temperature: 0 ~ 40 degrees C.
Excitation mode: permanent magnet type SGDV2R8FE1A000000600.
Installation method: flange type.
Heat resistance grade: F.
Insulation withstand voltage: AC1500V 1 minutes (200V), AC1800V 1 minutes (400V).
Protection mode: fully enclosed self cooling type IP67 (except shaft through part).
The use of environmental humidity: 20 ~ 80% (not dew).
Connection mode: direct connection.
Rotation direction: clockwise direction (CCW) rotation at the load side under the direction of rotationLarge capacity SGMVV type servo motor SGDV2R8FE1A000000600.
Rated output: 30KW.
Voltage: three phase AC200V.
Serial encoder: 20 bit absolute value type.
Rated speed: 800r\/min.
The main mechanical structure: support mounting type, straight shaft (with keyway and screw).
Optional parts: with hold brake (DC90V).
The use of small, low inertia servo motor, also can give full play to the strength of the mechanical properties.
The new model SGMVV with a rated output of 22~55KW, the amount of passenger speed 800r\/min and 1500r\/min products.
After the motor is installed, the phase is started to run immediately.
Even if the servo is not adjusted, as long as the moment of inertia is within the allowable range,
Even if the load changes, it can be driven stably, and the vibration will not happenEquipped with DeviceNet communication function type servo unit (external power drive type)
Maximum applicable motor capacity: 1.5kw.
Power supply voltage: three phase ac200v.
Interface: instruction selection and installation (rotary servo motor).
Match (hardware): paint.
Matching (software): standard.
Match (parameter): standard.
Optional modules: DeviceNet module (external power driver).
Specification for open field network communication based on DeviceNet.
The combination of the DeviceNet field bus controller and the V can be implemented in a simple way for motion control.
Can make use of the city''s rich DeviceNet support software.
Can use the upper controller to manage the servo information.
Monitor the running status of the servo drive system from the host controller through the network.
Using the upper computer to manage the servo information, improve maintenance (shorten the debugging time, improve the efficiency of maintenance operations).
Save wiring, reduce cost, improve reliability.
Because the upper controller and the servo unit are connected through the coommunication network, the connection is greatly saved SGDV2R8FE1A000000600.
Built in rich positioning function.
Can be from the upper controller (programmable controller or computer) on a variety of simple positioning action.
Equipped with simple poositioning, continuous rotation, and return to the origin of the continuous rotation movement, positioning, running and other rich positioning function SGDV2R8FE1A000000600.