SGMGV-13A3A6D Product Manual (Setup Rotational Motor)

Servo drive type SGDM.
Power: 400W.
Supply voltage: AC200V (single-phase / three-phase).
Mode: speed, torque, position control.
Design sequence: A.
Strong servo, flexible use of the explosive force, give full play to the mechanical properties.
Rapid and accurate transmission. In the moment of dodge opponent,
Send a powerful turn SGMGV-13A3A6D Product Manual. The fascinating world class players,
Requires its judgment, accuracy, speed and other parties, with a higher level of technology SGMGV-13A3A6D
For the performance of the servo system which plays a decisive role in the mechanical properties and production efficiency,
It is also required to respond to high speed, high speed and high precision control,
Have a higher level.







Large capacity SGMVV type servo motor SGMGV-13A3A6D Product Manual.
Rated output: 30KW.
Voltage: three phase AC200V.
Serial encoder: 20 bit delta.
Rated speed: 1500r\/min.
The main mechanical structure: flange type, straight shaft (with keyway and screw).
Optional parts: with hold brake (DC24V).
The use of small, low inertia servo motor, also can give full play to the strength of the mechanical properties.
The new model SGMVV with a rated output of 22~55KW, the amount of passenger speed 800r\/min and 1500r\/min products SGMGV-13A3A6D Product Manual.
After the motor is installed, the phase is started to run immediately.
Even if the servo is not adjusted, as long as the moment of inertia is within the allowable range,
Even if the load changes, it can be driven stably, and the vibration will not happenSigma -v series servo unit SGDV.
Maximum applicable motor capacity: 1kw.
Power supply voltage: three phase AC200V.
Design sequence: A type.
Interface: MECHATROLINK- III communication command type (rotary servo motor).
Matching (hardware): paint.
Realize real time communication
With the maximum transmission speed of 100Mbps and the set of communication cycle 125S ~ 4ms, to achieve a more than 62 stations of the high speed control.
Through the high speed of communication, can send and receive all kinds of control information in real time.
Contribute to cost savings
A maximum of 62 stations can be connected to the communication line, can significantly reduce wiring costs and time.
The command connector of the upper controller only needs 1,
Puulse generator for D/A converter or position instruction without speed / torque command SGMGV-13A3A6D Manual.
High precision motion control is realized.
In addition to torque, position and speed control, but also to achieve high precision synchronizzation phase control SGMGV-13A3A6D Manual.
Because the control mode can be switched on line, the complicated mechanical action can be realized more effectively and smoothly.