SGDV-101J11A001 USER'S MANUAL (For Use with Large-Capacity Models Setup)

Servo driver SGD7S.
Maximum applicable motor capacity: 0.05kW.
Voltage: single phase \/ three phase AC200V.
Interface: MECHATROLINK-II communication command type.
Design sequence: A.
Hardware options: paint.
Select servo.
Since the Yaskawa since the beginning of 1992 sales of sigma series, has always attached great importance to technical exchanges and customer,
In order to solve the new problem of customer machinery, and repeatedly to carry out technical innovation SGDV-101J11A001 USER'S MANUAL SGDV-101J11A001
High speed, high accuracy, the use of convenience in recent years has been the requirement of customers,
But the degree of its requirement is continuously deepening.
2014, the servo drive upgrade to have 7 major advantages",
Provide solutions for customers unique yaskawa SGDV-101J11A001 USER'S MANUAL.
With its excellent performance, convenient operation, long life cycle, etc.,
In all these areas will have great potential, provides solutions to the shocking. "Choose servo, choose"Servo motor SGMGH type.
Rated speed: 1000r/min.
Power: 2.0kw.
Power supply voltage: three phase AC200V.
Serial encoder: 17 bit absolute value.
Design sequence: B.
Shaft end: taper 1/10, with parallel key SGDV-101J11A001 USER'S MANUAL.
Optional parts: with oil seal, DC24V brake.
High speed feed series: high speed running when no load.
Complete separation of the main circuit and the control circuit,
Alarm can only turn off the main circuit power supply, easy to maintain.
Parameter setting device.
The parameters can be directly entered by the servo drive body.
Saving wiring.
Using a serial encoder, encoder wiring number than the original product reduced by 1/2.
Multi in one control: the use of the parameters of the switch can not use the torque, position, speed control.













Sigma -v series servo unit SGDV.
Maximum applicable motor capacity: 1.5kw.
Power supply voltage: three phase AC400V.
Design sequence: A type.
Interface: MECHATROLINK- III communication command type (linear servo motor).
Matching (hardware): base mounting type (standard).
Realize real time communication
With the maximum transmission speed of 100Mbps and the set of communication cycle 125S ~ 4ms, to achieve a more than 62 stations of the high speed control.
Through the high speed of communication, can send and receive all kinds of control information in real time.
Contribute to cost savings
A maximum of 62 stations can be connected to the communication line, can significantly reduce wiring costs and time.
The command connector of the upper controller only needs 1,
Pulsse generator for D/A converter or position instruction without speed / torque command SGDV-101J11A001 Manual.
High precision motion control is realized.
In addition to torque, position and speed control, but also to achieve high precision synchronizzation phase control SGDV-101J11A001 Manual.
Because the control mode can be switched on line, the complicated mechanical action can be realized more effectively and smoothly.